Repair IMEI for Qualcomm P50 Pro JAD-LX9 (EMUI 14.2) Using DT Pro Tool

Step-by-Step Guide: Repair IMEI for Qualcomm P50 Pro JAD-LX9 (EMUI 14.2) Using DT Pro Tool

Click here to download the required files | DT PRO TOOL

Tool Required: DT Pro Tool

Instructions:

1. Open DT Pro Tool: Launch the DT Pro Tool on your computer.

2. Select Brand Tab: Navigate to the "Brand" tab in the tool interface.

3. Choose Model: Select the P50 Pro JAD-LX9 model (with the latest security).

4. Connect Phone in Test Point Mode:

   • Place your device into Test Point Mode to generate the Qualcomm 9008 port.
   • In the DT Pro Tool, manually select the Qualcomm 9008 port.

5. Go to Special Task Tab:

   • Choose the "Special Task" tab and perform the following:
     • Backup Security (EFS/IMEI)
     • Backup Firmware

6. Change Storage Type:

   • Switch the storage type from Normal/Single RAW to Encrypted. This is necessary for resetting the EFS and loading the backup file.

7. Select RAW File:

   • Select the "Select RAW File" tab and choose the file named "(JAD) BootloaderImage.rev.dftpro".
   • Important: Make sure all partitions are checked.

8. Put the Device in Test Point Mode Again:

   
   
   
   • Once again, place the phone in Test Point Mode and click the "Write" button to begin flashing the file.

9. Flash the Bootloader File:

   • After flashing, you will hear a peculiar sound. Proceed to flash the backup file that was saved earlier.

10. Select RAW File for RPL:

    • Go to the "Select RAW File" tab and select the RPL file (this is the compressed file shared in the post).
    • Extract the .rar file and load the RPL file. Switch to Encrypted mode before proceeding.

11. Perform Test Point Again:

    • Once again, enter Test Point Mode and press the "Write" button to flash the RPL file.

12. Finish Writing RPL File:

    • After writing the RPL file, the Qualcomm port will remain open.

13. Enter Manufacture Mode:

    • Put the device into Manufacture Mode by entering the code: *#*#2846579#*#* On the dialer. The phone will display "DBAdapter Reserved Interface."

14. IMEI Repair:

    • Return to the "Special Task" tab and select the IMEI Repair option.

15. Enter Original IMEIs:

    • Copy and paste the original IMEI numbers. You will hear a familiar sound, indicating the process is successful.

16. Done: The IMEI repair process is now complete.