Redmi Note 13 5G (Gold) - POCO X6 Neo 5G – Mi Account & FRP Remove Solution (Tested 100%)

Redmi Note 13 5G (Gold) / POCO X6 Neo 5G – Mi Account & FRP Remove Solution (Tested 100%)

If your Redmi Note 13 5G (Gold) or POCO X6 Neo 5G is stuck on Mi Account, FRP, or Screen Lock, here is a tested solution that works 100%. Using SP Flash Tool, you can format specific partitions to remove locks and bring your phone back to life.

This tested method was successfully done by MindGSM Team.

Download File

📥 Download Tested File (Mediafire Link)

🔑 Password: MindGSMTeam

Why This Solution?

Many Xiaomi / Redmi devices come with strong security like Mi Account (Mi Cloud Lock), FRP (Factory Reset Protection), and Screen/User Data Lock. If you forget your account or password, you cannot use the device after reset.

With this method:

• Mi Account Lock Removed ✅
• FRP Lock Removed ✅
• Screen/User Data Cleared ✅

No need for premium tools. Just use SP Flash Tool with the correct partition addresses.

Format Address for SP Flash Tool

When using Format Address in SP Flash Tool, enter the values carefully:

🔑 Screen Lock (userdata)

BEGIN: 0x302800000
FORMAT LEN: 0xc0000000

🔑 Mi Account

BEGIN: 0xdc08000
FORMAT LEN: 0x3000000

🔑 FRP

BEGIN: 0x2b08000
FORMAT LEN: 0x100000

These addresses tell SP Flash Tool exactly where to erase the lock data without damaging the system.

Steps to Use (SP Flash Tool)

1. Download and extract the RAR file from the link above.
2. Install MTK USB Drivers on your PC.
3. Open SP Flash Tool.
4. Load the scatter file from the firmware.
5. Select Format → Manual Format Flash.
6. Copy the BEGIN ADDRESS and FORMAT LENGTH for the partition you want to clear.
   • First clear FRP.
   • Then clear Mi Account.
   • Finally, clear userdata if screen lock exists.
7. Connect the phone in power-off state with a USB cable.
8. Click Start and wait until you see the green tick.
9. Disconnect, reboot the phone, and setup as new.

Important Notes

• ⚠️ Formatting will erase all user data, including contacts, apps, photos, etc.
• Always use the correct scatter file for your device to avoid bricking.
• If the phone does not boot after formatting, flash the full firmware.
• This method is tested only on Redmi Note 13 5G (Gold) / POCO X6 Neo 5G.

Conclusion

This is the simplest and safest way to remove Mi Account, FRP, and Screen Lock from Redmi Note 13 5G (Gold). Using SP Flash Tool with the correct partition addresses saves time and avoids errors.

✅ Direct Flash + Format Done

• Mi Account Removed
• FRP Removed
• Screen Lock Cleared

Thanks to MindGSM Team for providing and testing this solution.